# pspec.inp : input file for pspec.f90 # # version V1.1 for sfit4 v0.9.5 October 1 2013 # # pspec.f90 loops through this file and creates an ascii file with a spectra block for # each spectrum that will be fit by sfit4 - the t15asc.4 file # the observation lat lon and altitude are required for each spectrum # Latitude of Observation [+N, 90 - -90] 40.038 # Longitude of Observation[+E, 0 - 360] 254.76 # Altitude of Observation [masl] 1612.0 # # output & verbosity flags # oflag - output # = 1 output t15asc file # = 2 bnr file # = 3 both # vflag - verbosity # = 0 no output from baseline correct or zero bnr or block output for plotting # = 1 verbose output from bc and zeroed bnr but no blockout # = 2 verbose, zeroed bnr and blockout for plotting 3 0 # # filter bands and regions for calculating SNR (max 100) # noise value is calculate in the region below that is nearest to the fit microwindow # SNR = (Peak signal in microwindow) / noise # 10 f1 3500. 3600. f2 3381.155 3381.536 f3 2924.866 2925.100 f4 2526.228 2526.618 f5 1985.260 1985.510 f6 1139.075 1139.168 f8 907.854 907.977 f9 4884.51 4885.2 a9 4990.99 4991.48 h6 1033.4 1033.6 # # number of bnr files 1 # # each block contains at least 2 lines: # bnr spectra file name # roe, nterp, rflag, fflag, zflag # # roe - radius of earth [km] # # nterp - zero fill factor # = 0 - skip resample & resolution degradation (regardless of sfit4.ctl:band.n.max_opd value) # = 1 - minimally sample at opdmax # > 1 - interpolate nterp-1 points upon minimal sampled spacing # note: OPD is taken from sfit4.ctl:band.n.max_opd value # # rflag - ratio flag, to ratio the spectra with another low resolution spectral file (eg spectral envelope) # = 0 - no ratio # = 1 - ratio, file is a bnr of same type as fflag below, expected to be resolution of ~10cm-1 # # fflag - file open flag # = 0 for fortran unformatted file # = 1 for open as steam or binary or c-type file (gfortran uses stream) # # zflag - zero offset # = 0 no zero offset, # = 1 try w/ baselincorrect, # 0 < z < 1 use this value, # = 2 use optimized 2nd polynomial fit to fully absorbed regions in 10m region # # roe, nterp, rflag, fflag, zflag # SNGC.bnr 6385.4 1 0 0 0 # # ratio file name in bnr format # if rflag eq 1 this file has to exist # skip if rflag eq 0 # ratio.6 # temp.bnr.00 1202.00 1204.00 256.0 6367.44 2 0 #ratio.6 # temp.bnr.00 1229.00 1230.00 256.0 6367.44 2 1 ratio.6